This is a very simple two way intercom circuit based on a LM390 audio amplifier circuit . the intercom circuit is a stand-alone electronic communications system intended for limited or private dialogue. For this circuit you can use a 8 ohms speaker, one for each station and require a 6 volts dc power supply. Gain control can be done by capacitively coupling a resistor (or FET) from pin 6 to ground.
LM390 Simple 2-Way intercom Circuit
LM390 Pin outThe LM390 Power Audio Amplifier is optimized for 6V, 7.5V, 9V operation into low impedance loads. The gain is internally set at 20 to keep the external part count low, but the addition of an external resistor and capacitor between pins 2 and 6 wil increase the gain to any value up to 200. The inputs are ground referenced while the output is automatically biased to one half the supply voltage.
No comments:
Post a Comment